Description

110V 220V 550W 1 m3/h 1000 L/h Micro Nano Bubble Generator, Gas Liquid Mixing Dissolved Air Flotation Ozone Water Pump

Note: 110V pumps need customization, the lead time is about 10-15 days.

The difference between a single pump and a whole set:

A whole set of micro-nano bubble generator contains a dissolved gas tank, which allows the gas and liquid to mix twice, thus producing much smaller bubbles.

While a single pump can only let the gas and liquid finish mixing once, so the bubbles will be relatively larger.

The gas-liquid mixing pump is a horizontally installed self-priming gas-liquid mixing pump series product. The pump body is a direct-connected motor structure. The structure and performance of the pump can match the pumps in the United States, Europe and Japan. The pump uses stainless steel castings.

The suction port of the gas-liquid mixing pump can use negative pressure to suck in gas, so there is no need to use air compressors and atmospheric ejectors.

The high-speed rotating pump impeller mixes and stirs liquid and gas, so no stirrer and mixer are needed.

Due to the pressurized mixing in the pump, the gas and liquid are fully dissolved, and the dissolution efficiency can reach more than 80%. Therefore, it is possible to prepare highly dissolved liquid without a large pressurized gas tank or expensive reaction tower. A gas-liquid mixing pump can carry out gas-liquid suction, mixing, dissolution and directly deliver the highly dissolved liquid to the point of use.

Therefore, the use of a gas-liquid mixing pump can improve the efficiency of the production of dissolved gas and liquid, simplify the production device, save space, greatly reduce the initial investment, and save operating costs and maintenance costs.

1. Inhale while sucking water, pressurize and mix in the pump, and the fine bubbles are 20-30 microns.2. High gas-liquid dissolving efficiency, stable performance, easy operation and easy maintenance.3. The air flotation device can replace pressurized pumps, air compressors, high-pressure dissolved air tanks, gas-water mixers and release heads, etc., to overcome the problems of unstable operation of traditional devices and large bubbles toppling.4. The ozone water production device can replace booster pumps, large-scale oxidation towers, etc., with a gas-liquid dissolution efficiency of more than 90%, which is 2-4 times higher than that of a Wen-type mixer, greatly reducing equipment investment and operating costs.

1. Thin, clean, low-viscosity liquid;2. Liquid temperature: -15℃ to +140℃;3. The highest ambient temperature: +40℃;4. The gas-liquid ratio is about 1:9 (inspiratory volume is 8-10%);

1. Dissolved air flotation treatment equipment (various types of air flotation devices).2. Ozone water production equipment (sterilization and preservation of pure drinking water, deodorization and decolorization of sewage to reduce COD, BOD, etc.).3. Oxygen-enriched water production equipment (oxygen-enriched drinking water, intensive fish and turtle breeding, hydroponic cultivation, etc.), and can also be used for the production of other gas-liquid mixed functional water such as nitrogen.4. Biochemical aeration equipment (domestic sewage, various industrial wastewater).

1. Install the water pipe and power cord for the machine according to the picture below, and fill the machine with water before use.

Remove the water inlet valve, lift up the water inlet hose, fill it with water, and after the water outlet valve comes out, put it back in the water inlet valve and tighten it by hand.

2. Turn off the gas flow meter, turn on the power, and wait for the machine to pump water normally (the sound becomes louder), then slowly turn on the gas flow meter and adjust it to the specified position. Pumping water within about 30 seconds will produce nanobubbles (the sound becomes smaller).

FAQ

1. How fast can I get the quotation?

We usually quote with 1 hours after we get your inquiry.If you ‘re urgent to get the price,please call us on ALIBABA/Whats’app/Skype/Wechat.

2. How can I get a sample to check quality?

1)Contact us and we’ll negotiate the best price possible for you.

2)Free sample:Sample cost can be refundable if your following order quantity is large enough.

3. Other payment methods?

1)To pay offline,You pay by T/T, Western Union and Paypal.We ‘ll send you our account information.

2)We’ll handle your order within 24 hours upon receiving cleared payment.

4. How fast can I get my package?

1)DHL :Southeast Asia 3-4 days / others 3-5 days

2)FedEx: Southeast Asia 3-4 days / others 4-6 days

3)UPS: Southeast Asia 3-4 days / others 4-6 days

4)TNT: Southeast Asia 3-4 days / others 4-6 days